Products
Hydraulic baling and shearing equipment for recycling and waste processing.
Fully Automatic Horizontal Baler
Continuous-feed horizontal baler with automatic bale ejection, for recycling lines that run through the shift without stopping to tie.
- OCC & cardboard
- Mixed paper
- Print & book stock
- Industrial waste
- +1
Semi-Automatic Horizontal Baler
Horizontal baler with manual wire tying, sized for yards that process a few tonnes an hour.
- OCC & cardboard
- Mixed paper
- Textile offcuts
- General light waste
Heavy-Duty Semi-Automatic Baler
Higher-tonnage horizontal baler for OCC, tube stock, drums and dense material. Same machine, different pressure ratings.
- Cardboard & OCC
- Paper cores & tubes
- Plastic drums
- PET bottles
- +1
Vertical Baler
Compact upright baler for smaller volumes and tight floor space. Manual to semi-automatic models.
- Cardboard
- Mixed paper
- Aluminium
- General store waste
- +1
Metal Baler
Hydraulic baler for scrap steel, stainless and non-ferrous. Front-ejection and twin-cylinder configurations.
- Light iron & scrap steel
- Stainless steel
- Aluminium
- Non-ferrous scrap
- +1
Guillotine Shear
Single-blade hydraulic shear for cutting heavy scrap to furnace-ready sizes. Hydraulic hold-down across the full cutting width.
- Heavy scrap steel
- Structural sections
- Pipe & tube
- Plate offcuts
- +1
Alligator Shear
Pivoting-arm shear for light to medium scrap, pipe and profile. Lower cost than a guillotine for smaller yards.
- Light to medium scrap
- Pipe & profile
- Cable & wire
- Sheet offcuts
- +1
Rebar Cutting Machine
Hydraulic cutter for reinforcing bar and thick section, sized for foundry and smelter feed preparation.
- Reinforcing bar
- Thick section steel
- Foundry feed preparation
- Smelter charge stock
Specialty Material Baler
Configurations for wood waste, sponge and other springy or bulky stock that standard chambers handle poorly.
- Wood waste & sawdust
- Sponge & foam
- Springy material
- Bulky low-density stock