Waste Paper & Metal Balers Built for Continuous Duty

Fully Automatic Horizontal Baler

Continuous-feed horizontal baler with automatic bale ejection, for recycling lines that run through the shift without stopping to tie.

• OCC & cardboard
• Mixed paper
• Print & book stock
• Industrial waste
• +1

Vertical Baler

Compact upright baler for smaller volumes and tight floor space. Manual to semi-automatic models.

• Cardboard
• Mixed paper
• Aluminium
• General store waste
• +1

Metal Baler

Hydraulic baler for scrap steel, stainless and non-ferrous. Front-ejection and twin-cylinder configurations.

• Light iron & scrap steel
• Stainless steel
• Aluminium
• Non-ferrous scrap
• +1

Guillotine Shear

Single-blade hydraulic shear for cutting heavy scrap to furnace-ready sizes. Hydraulic hold-down across the full cutting width.

• Heavy scrap steel
• Structural sections
• Pipe & tube
• Plate offcuts
• +1

Alligator Shear

Pivoting-arm shear for light to medium scrap, pipe and profile. Lower cost than a guillotine for smaller yards.

• Light to medium scrap
• Pipe & profile
• Cable & wire
• Sheet offcuts
• +1

Rebar Cutting Machine

Hydraulic cutter for reinforcing bar and thick section, sized for foundry and smelter feed preparation.

• Reinforcing bar
• Thick section steel
• Foundry feed preparation
• Smelter charge stock

April 22, 2026

Baler Maintenance Checklist for High-Volume Yards

Most baler breakdowns are hydraulic and most hydraulic failures start as contamination. A daily ten-minute check prevents nearly all of them.

February 10, 2026

How to Choose a Baler for Your Recycling Yard

Chamber size, throughput and bale density decide almost everything. Here is how to work out what you actually need before you ask for a quote.